(in your xbox go to) Settings, Network, Advanced Settings. Thats when I saw MY xbox one already there under 'XboxOne', You can ALSO look in your NETWORK SETTINGS IN YOU XBOX.

The whole trick for me was I was trying to use a different computer from the list to HOST the apps. After doing research, AT&T's routers do not have a UPnP feature (which is weird because I. My NAT type will not change from Moderate, and Network Settings always talks about a UPnP issue. My Xbox One recently decided to no longer want to have a solid connection. Then click save, and restart you XBOX One, Now you should see a OPEN NAT! Port Forwarding from AT&T U-Verse 5268 AC Router. Once all TCP and UDP numbers are added to the Name you gave the USER DEFINED APPLICATION (mine was 'xxxx Xbox 1', THEN you can ADD it to the HOSTED APPS from the Selected Menu!! If you have to use ports TCP 53, 80, 3074 like i did, then you must add them seperately., THEN you can add the UDP, mine were 53, 88, 500, 3074, 3544, & 4500 (Because these are the XBOX ONE ports that need to be opened! Then you can add the TCP and UDP numbers.įor instance: TCP 53 to 53, then ok, then ADD again, then TCP 80 to 80, then ok, Then ADD again. This is where you make a name for the xbox (whatever you want, mine was 'xxxx Xbox 1' Then clicked 'Add new user definied application' (2) Edit Firewall Setting in this Computer Ok, In my App, Pinholes, DMZ i went to where it says: After days of trying to figure out how to make my XBOX One NAT OPEN instead of Moderate I FINALLY figured it out!!

When your selections display in Hosted Applications, select Save.Hey guys.

Select the device name or IP address of the device from the Needed by Device drop-down, to open the port.

Your new applications or devices will display in the Applications list.

When all applications or devices have been added, select Return to NAT/Gaming.

Repeat as needed for additional applications and devices.

Select the appropriate Protocol from the drop-down for the application or device you are adding.In Base Host Port, enter the port number used for the first Global Port Range section.In this case the port number should be the same in the Global Port Range fields. It's recommended to create a separate service entry for each port as opposed to using a port range. Enter the port(s) you wish to open for Global Port Range.Enter the name for the application or device in Service Name.If you don’t see your application, or you’re setting up port forwarding for a device: Select the application for port forwarding from the Service drop-down.If you get a warning message, restart your Wi-Fi gateway.Enter the Device Access Code found on the side of your gateway.To open a port for user-defined applications:

How to change nat type to open uverse